The technology adopted by china laser pointer is more mature

The correct method of installation accessories. Data lines: parallel port connection to computer (two rows of fine needle-shaped), the other end to connect the machine output (in the right side of the machine front). Pump: the pump outlet received the machine aqueduct (length catheter), and then pump into the water (pump water work, short catheter water to form a loop cycle), plug in the pump power in front of the machine work, so that The water to be recycled in order to reduce the temperature of the laser tube. Exhaust: exhaust fan inserted in the exhaust port of the machine at the other end on the outside in order to discharge the flue. What other difference do red laser beam and green laser beam ofchina laser pointerhave besides the color?
CD-ROM: to install engraving machine typesetting software. Dongle: the use of software encryption to prevent malicious outsiders operation, no dongle, the software can not run the equipment plugged into the computer's USB interface software. Instructions: machine installation instructions and software installation instructions in two parts. Before you start the machine for the first time, you should first check the ground wire is grounded, the water to be recycled, power cable, data cable is connected. Press the power switch to turn the machine on, the first current adjustment: press the "test current" button, hold down the state. The technology adopted by china laser pointer  is more mature.
Adjust the "current regulation" button, the current in the proper position, release the test switch button, this way, the operating current of the machine is adjusted, under normal circumstances, the operating current in the 6-10 mA Depending on the chapter material, can be appropriately adjust the current size, the greater the current, the stronger the laser, the notch is about deep. Install the software: see the software installation instructions. Fang Zhang positioning: to see the software installation instructions or software help. Laser engraved chapter machine test. Chapter material on the fixture, so that the carved surface of the chapter material and plywood on the plane in a horizontal line, in order to seal to achieve the best results, wet paper, you can put one above the chapter material to cover the chapter material, in order to avoid the current is too large burn the chapter material, and then use the software layout engraved chapter. The red laser beam and green laser beam of the china laser pointer are also different in the power and energy consumption.
As long as you operate the equipment in accordance with the above steps that your machine will be able to quickly put into the production of them. 12 strokes of the ergonomics of the laser engraving machine to the limit. If you think laser engraving machine has yet to play to its maximum effectiveness, if you want to own laser engraving machine is more value for money, then carefully study the following 12 strokes, which will let you learn how to better The use of laser engraving machine laser power, the machine bed must have a good grounding protection, ground application of less than 4Ω dedicated ground. The necessity of lies. Can guarantee the normal work of the laser power to extend the laser tube life, to prevent outside interference cause the machine to beat, to prevent high-pressure discharge accidentally cause circuit damage. Good ground, be sure to be sure. The higher the power of china laser pointer is, the brighter the laser emitted by the laser pointer will be.
With tap water circulating pump, water flow must be maintained. The cooling water is taken away by the laser tube heat generated, the higher the temperature, the lower the light output power (15-20 ° C water temperature is better); without water when the laser cavity heat to cause the end of a pipe burst, or even damage to the laser power supply. So at any time to check whether the cooling water flow is necessary. When the pipes have a hard folding (bending die) or off, as well as pump failure must be repaired in time to avoid the power down and even cause equipment damage. Cleaning and maintenance, good ventilation, ready to wipe. If the red laser beam and green laser beam of green laser pointer have the same power, the consumed current will be still different.